Moderators: Webmaster, Stacy Clifford
Sal Bertucci wrote:
Now as for your duel. I would have to say just from looking at the two of you that there was an unequal level of skill between the two of you. His timing and intent are way off. I mean just from his positions and footwork that showed right off, and he is much less skilled than several other swordsman that I have personally met, so I feel like that is a weak point for your position.
When it comes to the cuts. I don't have any problems with the shoulder cuts that were shown, however, the wrap cut shown on the mat cut is not the same wrap cut thrown in video 3. You mention that the wrap is similar to the krump. While this may be true in theory, it is not in practice.
The wrap shot in video 3 would only have left a marginal cut on an unarmored person, and done nothing against even a gamblson. Now I will agree with you that when thrown as demonstrated with the mat, striking with the farthest part of the blade, you would have sufficient force to do significant damage. Often times with the wrap shot this is not the case as it is generally used once you've pressed shields to the other person. So I see no grounds for you wrap shot at all when it comes to the actual application.
Bill Tsafa wrote:
Against another shield its practical application is to get around the shield.
I think I was comparing the On-side to the Zwerchhue. I then explained that the wrap was a continuation of that motion. I don't think I mentioned the Krump anywhere. But the Krump is similar to a rolling cut I make in a windshield wiper motion. I did not test that on the mats.
Jay Vail wrote:
What I suggest you do is drop the shield and see what happens between the single sword vs longsword. Or go at him with a longsword of your own.
As to the famous "wrap shot," haven't you ever wondered why no historical source mentions such a blow? If it had been effective in a real combat, you'd think it would show up in at least one manual. There are descriptions of false edge blows with the one-hand sword, but not that one. That should tell you something, shouldn't it?
With regard to the wrap shot I believe it is mentioned in "Lecküchner's Messerfechten". I believe it is referred to "Sturzhau" (Plunging Stroke) also "Winckerhau". I think it is the sixth play of sword and buckler.
Jay Vail wrote:Bill, nice that you posted these vids, but they say nothing about the strengths of the SCA way over other approaches. If anything, they say that a sword and shield combination has advantages over an unarmored man with a longsword. I’m not sure that says anything important tho.
Personally, I regret to say that it does not appear to me that your opponent has been training that long or that he has much of a clue what to do in his situation. I played with SCA boys for a while after I started studying WMA and I was consistently able to hit the sword and board guys in the legs, even the thigh on the L side on occasion. I was also able to hit them on their R sides too quite a lot. It was clear, tho, that the shield is a considerable asset if it is assumed the longswordsman is unarmored.
What I suggest you do is drop the shield and see what happens between the single sword vs longsword. Or go at him with a longsword of your own.
As to the famous "wrap shot," haven't you ever wondered why no historical source mentions such a blow? If it had been effective in a real combat, you'd think it would show up in at least one manual. There are descriptions of false edge blows with the one-hand sword, but not that one. That should tell you something, shouldn't it?
Jaron Bernstein wrote:I have actually seen one example of what could be interpreted as the infamous SCA "wrap shot" in a manual. It is Meyer's dusack section.
The purpose of this topic is not intended to argue that SCA fighting is historical... it is intended to demonstrate that it is functional. From that point it may be argued that ancient and medieval people were just as smart and crafty as we are today and likely would have thought of and used a sword in any way that works
Return to “Research and Training Discussion”
Users browsing this forum: No registered users and 15 guests
|
|
|||
|
|
|||
|
|||